Wet Spot Super

This WET SPOT model is recommended for boats over 100 feet (Depending on how hard water is, and usage). This WET SPOT is for extra-large and/or built-in applications only. Before you buy a WET SPOT SUPER model, please realize that it is difficult for most people to single-handedly move on and off a docked vessel. Many clients have opted for two WET SPOT PLUS Models, instead of one WET SPOT SUPER model.

Every WetSpot comes with:

• 1 reusable recharge unit
• 1 small recharge hose
• 1 large service hose
• 1 soft water test kit

Specifications

• Length - 45"
• Width - 7.25”
• Height - 10.5”
• Weight - 50 lbs.

Model: SWS

Wet Spot Heavy Duty

This WET SPOT model is recommended for boats from 70 feet to 100 feet.

Every WetSpot comes with:

• 1 reusable recharge unit
• 1 small recharge hose
• 1 large service hose
• 1 soft water test kit

Specifications

• Length - 39"
• Width - 7.25"
• Height - 10.5"
• Weight - 45 lbs.

Model: WHD

Wet Spot Plus

This WET SPOT model is recommended for boats up to 70 feet.

Every WetSpot comes with:

• 1 reusable recharge unit
• 1 small recharge hose
• 1 large service hose
• 1 soft water test kit

Specifications

• Length - 34"
• Width - 7.25"
• Height - 10.5"
• Weight - 35 lbs.

Model: WSP

Recharger Kit

Recharger Kit with Hoses RCH02-1

Includes test kit, conditioner and hoses. Water softening rock salt is required and is sold separately.

Specifications

• Length 26"
• Width 9"
• Height 5.5"
• Weight 10 lbs

Model: RCH02-1

Re-charge Instructions

• Disconnect the main unit from long hose.
• Fill RECHARGER with rock salt and replace cap.
• Connect RECHARGER to water source with long hose.
• Connect short hose to other end of RECHARGER.
• Connect main unit to other end of short hose so that the arrow on top of the RECHARGER and arrow on top of the main unit are facing each other.
• You should now have the faucet, long hose, RECHARGER, short hose and main unit all connected together (in that order) with arrows on top facing each other.
• You may use either of these two configurations to obtain the best results: (A) Elevate the end of the WETSPOT, where water is coming out 6?-8?(A soda can works great!), forcing the water to fill the entire tank or
• Run the water at a fast pace and and restrict it’s exit using the valve on your Y attachment or sprayer! Where the water is going to exit the main unit should now be elevated or restricted.
• Turn the water on at a low G.P.M (approximately 1/2 gallon per minute) so that the water BACKFLOWS through the main unit slowly. This process should take about 15 minutes. Recharging is complete when the RECHARGER is empty of rock salt. If any salt is left in the RECHARGER, just turn the water on full speed for 1–2 minutes and it should dissolve.
• Flush all excess water from the WETSPOT prior to reconnecting your wash down or service hoses!
• Reconnect to the original configuration.
• Store RECHARGER, rock salt, hose and test kit.

You are now done recharging and your WET SPOT is ready to continue providing you with soft water!

Wet Spot Hose Set

WET SPOT Hose Set comes with (2) hoses – (1) 30' Service Hose and (1) 8' Recharge Hose. Works with any WET SPOT Unit

Specifications

30" Service Hose Model: SH30-5

8" Service Hose Model: SH08-5

Wet Spot Conditioner

A deep cleaning conditioner for your WET SPOT unit. Recommended 2-3 times per year.

Model: 4C-12

Wet Spot Water Test Kit

Spectrum Labs – Single Solution Hardness Test Kit is very sensitive and accurately shows whether your water is hard or soft. Comes with one .5fl. oz. bottle of a soap solution and one test tube container.

Model: TK010-12

Quick Disconnect Fittings

Nickle plated quick disconnect fittings allow you to effortlessly connect and disconnect your WET SPOT for easy mobility.

Model: NQD01-1